Sunken LinksPractice playbook · Vol. 01
Putting · Short game · Full swing

Practice with
a purpose.

20 illustrated drills from the r/golftips thread. Pick the shot you want to improve, see the setup, and give yourself one cue to swing with.

THE PRACTICE GREEN
The drill index

Find your fix.

Start with the 15-minute circuit above, or choose a section below. Distances and rep targets are starting points unless the thread gave a specific challenge.

Chapter 01 · 6 drills

Putting

Train the first foot of roll, then the last foot.

Distance control

Putting ladder

Putting ladder setup and motion diagramDISTANCE LADDERRoll each ball into its stop zone10 ft20 ft30 ftStartDistance shown schematically

Gear: Putter, 3 balls, 3 finish zones

Set up. Mark broad finish zones at 10, 20 and 30 ft on a level green. On a short mat, scale to 4, 6 and 8 ft.

Run it. Roll one ball to each zone, near to far, without using the cup. Then reverse the order.

Cue: Let stroke length set the speed.

Track it. Count how many finish in their zone out of 9. Start with each zone about 2 ft deep.

Speed under pressure

18 holes of lag putting

18 holes of lag putting setup and motion diagram18 LONG PUTTS · PAR 230–50 ft out · finish each hole in 21Lag close2Hole the next putt18 holes × 2 strokes = 36

Gear: Putter, ball, practice green

Set up. Pick a fresh angle to a cup each time. Start each hole 30–50 ft away.

Run it. Putt out all 18 holes. Score each as par 2. A one-putt is −1; a three-putt is +1.

Cue: Roll it close enough to tap in.

Track it. Even par or better is 36 putts or fewer. Start with nine holes if the green is busy.

Roll quality

Stripe-ball roll

Stripe-ball roll setup and motion diagramHALF-STRIPE ROLL CHECKDraw a line halfway around the ballMarkSteady stripeClean rollWobbling stripeCheck strike / face

Gear: Putter, marked ball

Set up. Draw a straight stripe halfway around a ball. Set it upright in the intended direction on a flat 4–6 ft putt.

Run it. Roll the ball and watch the stripe end over end. Repeat at the same pace and compare rolls.

Cue: Make the stripe look like a wheel.

Track it. Count 8 steady rolls out of 10. A wobble is feedback, not proof of a particular stroke fault.

Short-putt pressure

Compass drill

Compass drill setup and motion diagramFOUR-POSITION COMPASSMake the circuit · miss? Reset5–6 ft2–3 ftStart on the inner ring.Then move outward.

Gear: Putter, 4 markers, cup

Set up. Place four markers around the cup at 2–3 ft. Repeat with a second ring at 5–6 ft.

Run it. Hole one from each direction. Any miss resets that ring. Finish the inner ring before starting the outer ring.

Cue: Read all four putts. Don’t aim every one at the middle.

Track it. Make four in a row on each ring. Vary the slope once you can clear both.

Start direction

Start-line gate

Start-line gate setup and motion diagramSTART-LINE GATERoll the ball cleanly between two tees12–18 inGateChosen start line

Gear: Putter, 2 tees or flat markers

Set up. Pick a straight putt or aim down the intended starting line. Set the gate 12–18 in ahead, just wider than the ball.

Run it. Roll through the gate without clipping either side. Focus on the first foot of roll, not whether the putt drops.

Cue: Send it through the middle.

Track it. Get 8 clean passes out of 10 before narrowing the gate.

Aim and start direction

Chalk or laser line

Chalk or laser line setup and motion diagramALIGN TO YOUR START LINEUse a chalk line or laser as a referencePutter face square to lineBall stripe on start lineStraight-putt setup shown

Gear: Putter, removable line or putting laser

Set up. On a flat surface, lay a removable chalk line or use a stationary putting laser to show the intended start line. Use chalk only where allowed.

Run it. Square the putter face to the line. Roll 5 balls and watch where they first drift. Then remove the aid and repeat.

Cue: Start it on the line, not just toward the cup.

Track it. Try to keep 8 of 10 rolls on line through the first foot. Keep a laser pointed down and away from eyes.

Chapter 02 · 3 drills

Short game

Pick a landing spot and see how far the ball releases.

Carry control

Chipping ladder

Chipping ladder setup and motion diagramCHIP CARRY LADDERLand one ball in each zone123BallCarry distance increases →

Gear: Wedge, 3 flat landing markers

Set up. Lay out three landing zones, such as 3, 5 and 7 yd from a clean fringe lie. Use flat markers that won’t affect bounce.

Run it. Chip one ball to each zone in order. Score the first bounce, not where the ball finishes. Repeat far to near.

Cue: Pick the landing spot first.

Track it. Count first bounces in the intended zones out of 9; widen the zones to make it learnable.

Club selection and rollout

Three clubs, three feet

Three clubs, three feet setup and motion diagramTHREE CLUBS · THREE BALLSFinish each ball within 3 ft of the holePW8iSW3 ft from hole

Gear: PW, 8-iron, SW, 3 balls

Set up. Choose one fringe lie and one cup. Mark a 3 ft finish circle with flat markers.

Run it. Play one chip per club from the same lie. Let loft change the landing spot and rollout. Any miss restarts the set.

Cue: Same finish, three different flights.

Track it. All three must finish within 3 ft in the same set.

Up-and-down pressure

6–6–6 up-and-down challenge

6–6–6 up-and-down challenge setup and motion diagramUP-AND-DOWN CHALLENGEOne short-game shot + one puttEASYChip6 in a rowMEDIUMPitch6 in a rowHARDBunker6 in a rowMiss? Restart that station’s streak.

Gear: Wedge, sand wedge, putter

Set up. The commenter attributes this to Nelly Korda. Choose three lies: easy chip from the fringe, medium pitch and a bunker shot.

Run it. Play the short shot, then putt out. An up-and-down is two strokes or fewer. Get six in a row at each station; a miss resets that station in this practice version.

Cue: Treat every second shot as a putt you need to make.

Track it. Try 2–2–2 first. The full challenge is 6–6–6; track each station separately.

Chapter 03 · 5 drills

Ball striking

Use the strike mark and the turf as feedback.

Clubhead clearance

Outside-board drill

Outside-board drill setup and motion diagramFOAM GUIDE · TOP VIEWPlace outside the ball, parallel to target lineSoft foam guideTargetBallLeave clear clubhead space. Never use a hard board.

Gear: Iron or wedge, soft foam block

Set up. The thread uses a 2×4. Use a soft foam block instead. Set it parallel to the target line and just outside the clubhead at address, on the side away from your feet.

Run it. Make slow half-swings and hit the ball without brushing the block. Start with extra clearance and narrow it only if needed.

Cue: Miss the block, not the ball.

Track it. Try 8 clean contacts out of 10. A hit tells you where the clubhead was, not the entire swing path.

Ball-first contact

Penny ahead of the ball

Penny ahead of the ball setup and motion diagramFLAT VISUAL MARKERMarker sits 2 in beyond the ball, toward targetBallFlat marker2 inTargetVisual reference only; do not try to hit the marker.

Gear: Wedge, flat tape or chalk

Set up. The thread puts a penny a couple inches forward. Mark the same spot with flat tape or chalk so there’s no loose hard object to strike.

Run it. Hit waist-high wedge shots. Let the club brush the surface on the target side. On a mat, film from the side or use an impact mat for feedback.

Cue: Ball first, then brush forward.

Track it. Look for 7 of 10 centered strikes with the first ground mark on the target side.

Balance and contact

Feet-together irons

Feet-together irons setup and motion diagramFEET TOGETHERIron half-swings · quiet balance½½Small swing. Stay centered.

Gear: Mid or short iron

Set up. Set your feet close together, almost touching, with a ball near the center. Choke down slightly if that helps.

Run it. Hit short, smooth half-swings. Hold the finish without stepping. After 5 balls, return to your normal stance and keep the same tempo.

Cue: Finish balanced, not fast.

Track it. Aim for 4 of 5 solid strikes with no step to save your balance.

Strike awareness

Heel–toe–center

Heel–toe–center setup and motion diagramREAD THE STRIKEFace-on view of a right-handed ironTOECENTERHEEL

Gear: Iron, impact tape or face spray

Set up. Mark the face so you can see strikes. Use a short iron and a controlled swing. The heel target is on the grooved part of the face, not the hosel.

Run it. Try a toe-side strike, then heel-side, then center. Check the mark after every ball and repeat the set.

Cue: Predict the mark; then verify it.

Track it. Score how many intentional locations you actually hit out of 9.

Where the club meets the ground

Low point past the line

Low point past the line setup and motion diagramLOW POINT · SIDE VIEWBrush turf after the ball, toward targetBall / lineLow pointTargetRemove any alignment rod before swinging.

Gear: Iron, chalk or a line in grass

Set up. Draw a line across the target line at ball position. If you use a rod to make an impression, take it away before swinging.

Run it. Without a ball, make short practice swings and look for the first brush mark on the target side. Add a ball only after the feedback is repeatable.

Cue: Brush the turf on the target side.

Track it. Aim for 7 first marks past the line out of 10. On a mat, use a contact board designed for golf.

Chapter 04 · 6 drills

Swing feel

Rehearse slowly. Keep only the feels that improve your shots.

Transition and release

Split-hand rehearsal

Split-hand rehearsal setup and motion diagramSPLIT-HAND SWINGSHands apartSlow half-swingsFeel the club release

Gear: Iron; no ball to start

Set up. Take your normal grip, then slide the trail hand 2–3 in down the grip, keeping both hands on the rubber.

Run it. At rehearsal speed, let the arms lower as you turn through. Let the club release with the turn. Switch back to your normal grip for a ball.

Cue: Lower, then turn through; don’t throw the head from the top.

Track it. Alternate 3 slow split-grip rehearsals with 3 normal-grip half shots.

Wrist motion in transition

No Turn Cast

No Turn Cast setup and motion diagramNO TURN CAST · THE FEEL1 · Set the wrists2 · Release from the topBody still turns. Arrows show feel, not a literal shaft path.

Gear: Iron; no ball at first

Set up. This is Monte Scheinblum’s named feel, not an instruction to freeze your body. Rehearse a wrist set as the swing moves back, without forcing an extra turn.

Run it. From the top, feel the wrists release sooner than usual as the arms start down. Keep turning through; don’t try to scoop the ball. Watch Monte’s demonstration before adding a ball.

Cue: It’s a feel drill, not a position to force.

Track it. Try 3 slow rehearsals and 3 soft shots; keep it only if strike improves.

Rotation and delivery feedback

Alignment-rod “hell drill”

Alignment-rod “hell drill” setup and motion diagramALIGNMENT-ROD RELEASE CHECKSoft trainerextends above gripSlow rehearsalNo ballTurn through together; do not flip the wrists.

Gear: Soft foam trainer; no ball

Set up. The thread has you extend a rod above the grip. Skip rigid rods near your ribs. Use a soft foam trainer for a slow rehearsal with plenty of clearance.

Run it. Make small, slow motions through impact. Keep turning so the extension travels around with you rather than swinging into your side. Stop if it contacts you.

Cue: Turn through instead of flipping the club at the ball.

Track it. Do 5 slow reps without contact. Never swing fast or hit a ball with an improvised extension.

Takeaway and wrist set

Faldo wrist preset

Faldo wrist preset setup and motion diagramFALDO PRESET · TWO CHECKPOINTS1 · Hinge at address2 · Turn backShaft level · parallel to targetLet your chest carry the club

Gear: Iron; rehearsal first

Set up. The thread only says Faldo; this is his wrist-preset version. Take your address, then pre-hinge the wrists so the shaft is roughly parallel to the ground and the target line without turning the body first.

Run it. Turn from that preset to finish the backswing. Rehearse the sequence, then try a smooth short shot from the preset if it feels stable.

Cue: Set the wrists, then turn.

Track it. Alternate 3 preset rehearsals with 3 normal swings.

Rhythm and release feel

Towel release

Towel release setup and motion diagramTOWEL RELEASE · NO CLUB OR BALL1 · Let it trail2 · Let it unfurlStart the motion smoothlyTurn through at easy speed

Gear: Small hand towel; no club or ball

Set up. The thread only names a towel drill for release. This is a gentle towel-swing version, not the underarm connection drill. Hold one end and clear the area.

Run it. Make a small backswing. Turn smoothly through and feel the loose end follow, then unfurl. Don’t whip it hard or use a knotted or weighted towel.

Cue: Let the towel follow, then release.

Track it. Make 5 smooth repetitions without yanking the towel from the top.

Hip depth through the swing

Hips against the wall

Hips against the wall setup and motion diagramWALL / HIP-DEPTH CHECKWallHips stay backas you rotateAvoid movingtoward the ball

Gear: Wall; no club or ball

Set up. Set up in golf posture with your glutes lightly against a wall. Cross your arms over your chest.

Run it. Turn back until your trail glute brushes the wall. Turn through until the lead glute replaces it. Don’t force both sides to stay pinned.

Cue: Trail pocket back, then lead pocket back.

Track it. Try 5 slow turns without your hips moving toward the imaginary ball.